How close Slate Floor

Slate floor is a traditional style of flooring that is made with natural stone . It is considered very environmentally friendly as it is cut rather than manufactured . There is also a form of soil that has been used for hundreds of years and is very durable. However, slate flooring is a porous material , so it can stain if not sealed material . For this reason , you should always make sure that this type of flooring is sealed when first installed and then re-seal if necessary.

preparation

In the preparation process of resealing , you must first remove any old sealant that is still on the ground . This whole process can take time, but it must be done correctly to protect your floor.

Knowing that the Board is resistant to stains and dirt particles can cause serious stains. The floor should be swept to remove dirt and other particles must be as clean as possible . You need to remove any old wax sealant that may have been on the floor. To do this, you must apply a wax remover slate ago near a square 4 feet by 4 feet at a time. Once the right to sit for a while, should be cleaned with a mop to clean remove wax softened water .

Once you have finished the entire floor , then apply a neutral PH clean slate with a mop . This will clean the floor should be ready to apply the new sealant. Rinse floor and let it dry for about three days .

new sealant

To reseal the process must use a slate sealer is available at many hardware stores. You must pay the sealer in a paint tray and dip the paint roller. It’s a good idea to start applying a thin coat of sealer to the floor farthest from the door in order to prevent leakage corner .

Once you have covered the entire floor, you have to let the first layer dry. Once done , the second layer is applied , but this time going in the opposite direction of the first layer. Allow the paint to dry for the next 24 hours. When this is done , you will have a slate stain -resistant floor that will last for many years.

Leave a Reply

Your email address will not be published. Required fields are marked *